Seiko Precision, Inc.

SK-3000 AI / SK-3005 AI

SK-3000 AI (no color)
Printer: Narrow Carrage (80 Columns, 10"), 9 pins
Ribbon: MP-13051
Emulation(s): Epson FX-80, IBM 5152 Graphics Printer

SK-3000 AI (color)
Printer: Narrow Carrage (80 Columns, 10"), 9 pins
Ribbon: MP-13055
Emulation(s): Epson JX-80, Epson EX-800

SK-3005 AI (no color)
Printer: Wide Carrage (132 Columns, 15"), 9 pins
Ribbon: MP-53051
Emulation(s): Epson FX-80, Epson FX-100, IBM Graphics Printer

SK-3005 AI (color)
Printer: Wide Carrage (132 Columns, 15"), 9 pins
Ribbon: MP-53055
Emulation(s): Epson JX-80, Epson EX-800, Epson EX-1000

* All versions of Microsoft Windows have both the IBM and Epson print drivers bundled with them. Seikosha does NOT supply these print drivers. The only drivers Seikosha supplies are for special printers located in this list.

DIP SWITCH SETTINGS

The switches are located at the back of the printer.

Note: The printer's power must be turned OFF before making any DIP switch changes.

The DIP switches are read after the initialization process either by turning the power switch on or inputting the INITIAL signal of the parallel interface.
When shipped from the factory, all switches except for international character switches are turned OFF.



DIP Switch Bank 1


Table 1
Note 1: Standard and IBM modes are selected only by using DIP switch 1-5. There is no control code to designate Standard or IBM mode.

Note 2: In Standard mode, DIP switch 1-6 determines whether a download character is valid or not. When a download character is valid, the space within the communication buffer is decreased from 10K bytes to 7K bytes (SK-3000) or from 6K bytes to 3K bytes (SK-3005).

International Characters Selected by DIP Switches

Table 2

Note 1: These character selections are valid for all the character sets: Standard character set, IBM character set 1, and IBM character set 2.

Note 2: When DENMARK is selected in the Standard Character Set and in the IBM Character Set 1, the above DENMARK characters are available. However, when DENMARK is selected in the IBM Character Set 2, the U.S.A. characters become available, and the code (9B)Hex or (155)Decimal corresponds to the print-out of a small slashed zero and the code (9D)Hex or (157)Decimal, to the print-out of a large slashed zero.

DIP Switch Bank 2

a. CSF mode selection



b. Serial transfer rates



c. Serial protocol and parallel selection



d. Parity selection



e. Serial data length





Return to Seiko Precision's main page
[RESIST INTERNET CENSORSHIP. GET INFORMED.]