Seiko Precision, Inc.

SL-80 AI

Printer: Narrow Carrage (80 Columns, 10"), 24 pins
Ribbon: SP-16051
Emulation(s): Epson LQ-1500, IBM 5152 Graphics Printer

* All versions of Microsoft Windows have both the IBM and Epson print drivers bundled with them. Seikosha does NOT supply these print drivers. The only drivers Seikosha supplies are for special printers located in this list.

DIP SWITCH SETTINGS

Note: The printer's power must be turned OFF before making any DIP switch changes.

The switches are located at the back of the printer under the plastic lid.

The DIP switches are read after the initialization process either by turning the power switch on or inputting the INITIAL signal of the parallel interface.
For the DIP switch 1-7, however, its changeover is always valid.

When shipped from the factory, all switches except for international character switches are turned OFF.



*1 If the power is turned on with this DIP siwtch 1-1 set ON, the printer is put in the error state.
*2 If DIP switch 2-4 is turned ON, a skup-over perforation area of 1 inch is set.


Table 2. International Characters Selected by DIP Switches

Note 1: These character selections are valid for all the character sets: Standard character set, IBM character set 1, and IBM character set 2.

Note 2: When DENMARK is selected in the Standard Character Set and in the IBM Character Set 1, the above DENMARK characters are available. However, when DENMARK is selected in the IBM Character Set 2, the U.S.A. characters become available, and the code (9B)Hex or (155)Decimal corresponds to the print-out of a small slashed zero and the code (9D)Hex or (157)Decimal, to the print-out of a large slashed zero.



Return to Seiko Precision's main page
[RESIST INTERNET CENSORSHIP. GET INFORMED.]