SP-2000 AP

at Seikosha





« SP2000
SP-2000 S »

SP-2000 AP

SP-2000 AP


Printer: Narrow Carrage (80 Columns, 10″), 9 pins
Ribbon: BP-16051
Emulation(s): Apple Imagewriter I

* All versions of Microsoft Windows have both the IBM and Epson print drivers bundled with them. Seikosha does NOT supply these print drivers.


DIP SWITCH SETTINGS

Note: The printer’s power must be turned OFF before making any DIP switch changes.

CAUTION: If you have been printing, allow the print head to cool down before touching it.

To set the DIP switches:
1. Open the printer cover.
2. Remove the ribbon cassette.
3. Manually push the print head to the right side of the printer.
4. Grasp the fin of the compartment cover on the mechanical frame. Slide it to the left, and remove it.

After setting the DIP switches, replace the compartment cover, re-install the ribbon cassette and replace the printer cover.

The DIP switch settings are read only after the initialization process when the printer’s power is turned ON, or inputting an ESC c command.


*: When 7-bit data length is selected, the printer ignores the 8th bit (MSB) of data within the printer.

Language Fonts Setting Table

* U.S.A. fonts are selected as shipped from the factory.

This entry was posted on Monday, October 19th, 2009 at 5:13 am and is filed under Support. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Leave a Reply

Enter your email address:

Delivered by FeedBurner





Webdesign by ELIMEDIA that best fit your needs.